Triumph 675 Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
290 Posts
Discussion Starter · #1 ·
I installed new levers on the bike, changed the front brakes, then tried to start it...It cycled on like normal and when I hit the ignition button, nothing happened. Not even a click. Battery is on a tender and kill switch is off. What could be the problem?
 

·
Registered
Joined
·
36 Posts
clutch cable not correctly hooked up? thus not registering to the bike that it is pulled in, and hence no start? maybe
 

·
Banned
Joined
·
365 Posts
it couldn't be anything else but the clutch pull.
Someone here would know exactly how the bike senses the clutch is in
Resetting the ECU never hurts as 675 electrics can spaz out pretty easily.
 

·
Registered
Joined
·
3,327 Posts
+1 on the clutch switch, but maybe the tender doesn't help ?
 

·
Registered
Joined
·
90 Posts
Yes, sounds like you may not have set the new lever properly with the clutch switch. and +1 on not starting it up while connected to a tender. Disconnect it before start-up
 

·
Registered
Joined
·
290 Posts
Discussion Starter · #6 ·
Ok. Thanks guys. I will try and re-set the lever. Thanks for the tip about not starting it while it is on the tender. I have done this in the past, but won't continue to do it.
 

·
Registered
Joined
·
290 Posts
Discussion Starter · #7 ·
Yep, that was the problem. When I loosened the bolt on the clutch perch, it fired right up. I will just have to set it properly and I should be good. Thanks for everyone's help.
 
1 - 8 of 8 Posts
Top