Triumph 675 Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
490 Posts
Discussion Starter · #1 ·
I just purchased the Fender Eliminator kit. It doesnt come with DIY instructions, and I searched the internet with no results. Does anyone know where I can find DIY installation instructions
 

·
Registered
Joined
·
752 Posts
I just purchased the Fender Eliminator kit. It doesnt come with DIY instructions, and I searched the internet with no results. Does anyone know where I can find DIY installation instructions
It just goes where your passenger pegs are currently located at, and uses the same hardware. just undo the nuts on the mount bolts, put the fender eliminator on, then put the nuts back on. REALLY easy.

FYI. you might as well take off your rear tire hugger now because your license plate it going to hit it as soon as the suspension compresses.
 

·
Registered
Joined
·
389 Posts
Angle the license plate/holder towards the front....better clearance, make sure it is visible though so you don't get pulled over right away. I have two brothers and I am sure it is almost the same.
 

·
Registered
Joined
·
490 Posts
Discussion Starter · #5 ·
thanks
 
1 - 5 of 5 Posts
Top