Triumph 675 Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-13 of 13 Results
  1. Repair/Troubleshooting
    Hello I recently purchased a 2011 Daytona and rode it 2 hours home after purchasing and the next day it wouldn't start have went through the forum and determined it was a bad stator and CPS but am also changing the r/r as well. After receiving the new parts and gasket I went to start replacing...
  2. Repair/Troubleshooting
    This is a new to me D675R so I'm not sure if this is an issue or just how it is, but my cables bump into the dash every time I turn left... also, they look like a hot mess (see end of video). Anyone know if this needs to be fixed? Thanks so much in advance for your time!
  3. Repair/Troubleshooting
    Hey all, so I have a 2009 Daytona 675 that I've been doing a full rebuild on. I'm putting things back together and came across this one connector that I can't find the other side to (of course it's the one connector that wasn't labeled). It seems like it should be pretty obvious but I can't...
  4. Electrical Section
    Hey folks, I am a newbie here so forgive any faux pars on my account. I have a 675 track bike for which I did a half decent wiring loom modification last year. I am now onto track loom 2.0 but I am finding I am a little limited by my knowledge. I have searched the forum and many of the threads...
  5. Electrical Section
    Do you know anything about our bikes' electrics, wiring and or tail lights of the 675? If so, please help me out. Last night, me and my buddy spent four hours trying to install the Motodynamic integrated tail light on my Daytona 675 2010. Just to clarify, the bike is an EU bike and the tail...
  6. Electrical Section
    I purchased a 2012 daytona 675r (vin 502908) last year with 150 miles on it and it was throwing a code for the EXBV position sensor short out [P1078]. I loaded up tuneecu and turned off the EXBV and that cleared the code and since then I haven't had any problems with the bike. While doing some...
  7. Maintenance and repair
    Hey guys, new to the forum here but am in need of some big help! Wondering if anyone might currently have their tank off of their bike and could snap a quick picture the wiring underneath. I spun a rod bearing last season so found a complete engine with low miles on ebay. I put the engines...
  8. Electrical Section
    Hello, New member here.. I recently found a 2008 675 Daytona that was in a wreck. the front is all messed up (forks,wheel,frame, bars) I'm thinking about sourcing a frame and starting the rebuild process. I would just like to hear it run before I start dropping $ on parts. It did not come...
  9. Maintenance and repair
    I installed a fender eleminator kit last week and disconnected the battery before doing so. When I was done everything worked but the check engine light was on. I hoped after a few cycles it would clear itself but no such luck. I pulled up the tank today and noticed a disconnected wiring...
  10. Repair/Troubleshooting
    I have a 2010 Street Triple R and the tail light wire is shorted to ground somewhere between the fuse block and where the harness exits under the rear part of the fuel tank. Saw that with the Speed Triple that it has happened with the starter ground wire and yellow tail light wire under tank...
  11. Maintenance and repair
    Im looking for anyone who can email me a copy of their service and repair manual. I have the one that came with my bike, but I'mneeding the one that goes more in depth with the motor and wire harness specifically. Any help would be greatly appreciated.
  12. Parts
    Side stand w/ sensor (new): 15 09-12 Regulator (new): 90 09-12 Wiring Harness (new): 180 Headlight switch (used, scratched): 15 Rear Pegs (used): 45 Heat Shield (new): 15 525 Chain w/ Front & Rear Sprockets (used): SOLD 09-12 Sprocket Cover (new): 20 ||| 06-08 Sprocket Cover...
  13. Modifications
    Hi, The front of my bike is currently in bits as i'm trying to wire in a set of heating pads that sit under the stock grips. I've been told the headlight circuit is fine to use so I've stripped the front fairing off, only to see 4 wires on the connector and not have any idea which is the 12v...
1-13 of 13 Results
Top