Triumph 675 Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Maintenance and repair
    2013 Daytona 675R There are a couple things going on that i think are all related to the same problem -when i start bike, fuel guage does not display near correct qquantity or will say that there is no fuel in the tank. (has been fixing itself as i start riding for a few minutes) -rough and...
  2. General 675 discussion
    Hi everyone, I removed my cat from my daytona 675 07.. And i have a yoshimura slip on now.. Is there anything i should do next or can i just ride as it is now?? Thanks
  3. Repair/Troubleshooting
    Long story short I let someone else work on my 07 675 and the put a tune on it without my permission and now if you use more then 3/4 throttle it bassicly auto cuts the fuel so it starts to stall untill you let off the throttle and then it goes back to normal until you repeat going beyond 3/4...
  4. Repair/Troubleshooting
    Ok so i have had this bike (2011 675) for about 6 months. All goin good noticed if id ride down to the servo 10 mins away that it would be hard to start back up after fuel. That wasnt to bad well... then it started getting a cut after a long pretty heavy fisted ride after say id come off the...
  5. Maintenance and repair
    I installed a fender eleminator kit last week and disconnected the battery before doing so. When I was done everything worked but the check engine light was on. I hoped after a few cycles it would clear itself but no such luck. I pulled up the tank today and noticed a disconnected wiring...
  6. Repair/Troubleshooting
    The other day I put my key in the ignition and moved it to the ON position. I immediatly heard a loud pop. At first I thought it might have been a fuse blowing. After opening the fuse box and inspecting them I turned back on the bike again and instead of hearing the popping noise I kept hearing...
  7. Modifications
    I have been, and for the next month or so will be working on my bike to get it finished for summer. I have just finished the following list of jobs and the engine light has come on... I think it could be from removing the Ram air intake 'flapper' and solenoid from on top of the intake aswell as...
1-7 of 7 Results
Top