Search Results for ‘daytona’

Hello guys I am a new member and I have a problem i am an owner of daytoona 675R that is a model made in 2012 i think but in fact i had an accident and i did lost the counter , my old one has a blue screen with 18 thousand RPM it’s the same in the picture below 👇 i did search everywhere for a...

Hey how's it going, I've got a 06 Daytona and a Bluetooth obd2 reader from Veerpeak. I'm running Tune Ecu and have the €25 licence. When I connected to the ecu it connects quickly without fail. But when it asked me to register my bike I tried but you need internet connection (I'm down in my...

Hello people! I am based in Toronto and I recently bought a 2014 Triumph Daytona ABS. It had clocked about 14K kms and all services were done on time but it seemed like the bike was sitting for a while last year. I rode it for a few thousand kms and didn't have any issues with it, however, today...

Hey 👋 I have a 2006 Daytona 675 Triple, when I press the ignition it makes no noise, no lights turn on, nothing though the dash lights up as it should etc. Key points: new battery new gas solenoid fuse good (bike had started up a month prior) I'm stuck 🤷 any help to get her up and running...

Hey Yall, I've been searching for weeks for a fuel pump assembly for my 07 DT 675. Everything used on ebay is almost 400 bucks where as new models of fuel pumps are going for less than 200. Smh. I have checked the aftermarket market thread to see of there was any compatability with another...

As the title says I’m looking at a set of 2008 daytona cams that I’d like to swap into my 2015 street triple. reckom it’ll complement my GPR slip on and BMC filter nicely. My question though is when it comes to dyno and tuning do I need a PCV because they’re hard to come by here in Thailand...

So I just got myself a 2014 daytona 675. The yuasa battery in it is 2 years old. Last week I turned off the bike at a red light and it refused to start over (starter motor was struggling to rotate as would with a low voltage battery). So I got the battery charged overnight and the bike has been...

Hey y’all, very new to the forum so apologies if this has been asked many times prior. New to officially riding on the street, looking to get into that. Have about 10 years prior experience with MX. My question is, two dealerships have these 2013 Daytona 675: $7k with 11k miles 2014 Street...

Hey just after some info or a photo of the back of someone's dash need to know which wire is what on dash cluster as had an accident and cluster wires got pulled out of the plug I'll try add a picture ☺️

Hi All; Long time since been on here. I have an issue that I have noticed for a few years now, and this weekend really bugged me. It appears I loose power at Altitude. I live at +600m (~2000ft) ASL, and work at +50m ASL, and whenever I visit the high country which is starting at +1500->1860m...

Triumph Daytona 675 stock exhaust muffler for 2009 2010 2011 and 2012. This one came off of my 2010 Daytona after 10,000km after being replaced with an Arrow system. Condition is used with normal signs of wear; see photos. Includes the carbon fiber end cap, which is an OEM piece as well. Asking...

I have a fiberglass race tail fairing from my 2012 Daytona 675R which I don't need. It's a standard fairing which uses the OEM seat (e.g. supersport tail). I think its a Sharkskins, but not 100% sure. Its not a show piece but very solid & 100% usable as-is. The decals are on top of the clear and...

Hi all, currently looking at my first Triumph Daytona 675 2009. Looking for some general information on them; known issues, potential mods etc. Not too experienced with this brand so was hoping to get some insight! Thank you.

From a 2007 daytona 675. Woodcraft rearsets. I believe they are complete. Might need a bolt or two but those are inexpensive. Instructions and stickers(may not still stick) Slight rash on brake lever tip. Also had bolt strip so i had to grind bolt off. so there is slight cut on one side of...

Heyy so my name is Mika and I'm 21yrs old. I've Been riding a little over a year now. I started on a 2012 CBR 250 and when I was ready I moved up to purchasing my first bike. I bought a 2011 R6 and loved it but July 1st I was in a bad accident that almost took my life. I flipped 6 to 7 times but...

This is a feeler as I'm thinking ways of parting with my Daytona, which used to belong to a member on here. The bike was extremely mint when I bought it and I've kept it the same, meticulously looked after, always stored in heated garage. I bought the bike with 3K-ish miles, and now it has 12K...

Hi! i am from Chile, SouthAmerica, i just bought my first motorcycle from EE.UU. it's a Triumph Daytona 675 2009, in 1 month arrive to chile... i am really exciting... this is my motorcycle.. https://www.copart.com/lot/33761367 i just need to buy some pieces that are broken, like the left...

Hi!, i am new here, and i want to change the rearset of my daytona 675 2009, i want to go with a Woodcraft rearset, and i want to put the sensor of brake light with out zipers, but i dont know if is M10x1.00 or M10X1.25 https://www.revzilla.com/product/woodcraft-brake-light-switch Can you help...