Error Code P1698 - Triumph675.Net Forums
Maintenance and repair Problems, fixes, general maintenance talk

 
Thread Tools Display Modes
post #1 of 3 Old 09-19-20, 23:08 Thread Starter
_.Andypants
Junior Member
 
Join Date: Dec 2018
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
Error Code P1698

Ok buckle up because this one is a doozy. Last week I started doing the 12k mile service on my 2013 Street Triple R. I did my steering head bearings and fork oil without any major problems. Took a few days off and then jumped into checking my valves. I get everything off without too many problems and it turns out all my exhaust valves are tight. So I go in for the night and after work the following day I pull my cam bracket thing off and remove measure and purchase new shims. I get the cams put back in and lined up correctly. Throw the bracket thing back on, torque it to spec and put on my new manual cam chain tensioner. I look up the directions on their website and they say to tighten it until it makes contact with the cam chain and then back it off a quarter of a turn. So I do exactly that. I manually crank the bike and on my third crank I hear a pop. The intake cam skipped a tooth. So I take the cams back out, realize I am not set at tdc on the dot and smack myself in the face. I figure out when the first cylinder is at tdc, line up the dot and put the cams back in. I call it a night and proceed the next day. I realize I could have put cylinder 1 at tdc on either the exhaust or the compression stroke. I google a bunch about what would happen if I set the cams on the exhaust stroke and came to the conclusion that because I was setting the valve timing I should be ok. I get most everything put back together except for the airbox because I would have to sink my throttle bodies next. Check that everything is connected right. Cross my fingers and hit the starter. It turns on, I hear some ticking and then it dies. I grab my laptop and dealer tool and check for codes as there is a check engine light on and I get : P1698 Sensor 5v supply, circuit malfunction. I do some googling and realize that code could be the air sensor thing, r/r or ecu. Am I screwed?
_.Andypants is offline  
Sponsored Links
Advertisement
 
 

Bookmarks

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Triumph675.Net Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Threaded Mode Threaded Mode


Forum Jump

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome