Member
Join Date: Jan 2008
Location: Minneapolis
Posts: 687
Thanks: 14
Thanked 25 Times in 23 Posts
+13' Triumph Daytona parts not needed for the track
This was all removed from a 2014 Daytona 675R with only 900 street miles. (Actually I bought the bike with about 900 street miles and then put about 200 more street miles on it before I began the tear down)
Price is "shipped" ONLY to the lower 48.
ECU/Harness/Immobilizer are located in Blaine MN
ECU with wire harness and immobilizer (1,1xx miles for ABS bike) $300
This was all removed from a 2014 Daytona 675R with only 900 street miles. (Actually I bought the bike with about 900 street miles and then put about 200 more street miles on it before I began the tear down)
Lower exhaust heat shield (the black metal lower trim that is part of the body work) $30 / SOLD
OEM 525,15/47 chain and sprocket set (you will need a 525 master link) $75 / SOLD
OEM 525 47T rear sprocket $25 / SOLD
Idle stepper motor $50 / SOLD for $30
SAI (hoses, covers, reed valves, etc.) $25 / SOLD
Headlight / horn handle bar switch (Clutch side) $30 / SOLD
Passenger seat $50 / SOLD
Rider seat $75 / SOLD
Clip-on's w/grips throttle tube and bar ends $70 / SOLD
Mirrors $40 each / SOLD
Head light assembly $175 / SOLD
Turn signals $30 / SOLD
Rear fender w/turn signals $40 / SOLD
OEM plastic oil filer cap w/O-ring $10 / SOLD
Accessory Triumph paddock stand bobbins (black) $20 / SOLD
Passenger seat $50 / SOLD
Lock set, (Key, ignition, fuel cap, seat lock. I had a lot of difficulty drilling out one of the ignitions mounts from the triple clamp so I wound up putting an angle grinder to it. The mount is still fully functional and the damage from the grinder will not be visible. You will need to have the key/ignition paired with your bike by a dealer.) $80 / SOLD
Full OEM Exhaust system w/Exup, O2 sensor and body trim panels $150 / SOLD
Right rearset (brake side) $75 / SOLD
Triumph 10-15L Tail pack (new in the plastic) Its my understanding that this pack works for various 675s. You will need to go buy a specific mount harness for your bike at a dealer for this to work. The harness runs about $15. $50 Tail pack with no harness / SOLD
Parts thrown out 11/2019
Right passenger foot rest (brake side) $40 / THROWN OUT
Evap loss canister and hoses $15 / THROWN OUT
Tail/Brake light $30 / THROWN OUT
Air filter $25 / THROWN OUT
Side stand with switch $20 / THROWN OUT
ABS brake system with pulser rings and wheel speed sensors $100 / THROWN OUT
Engine infill cover (black plastic piece above the sprocket cover on the clutch side) $20 / THROWN OUT
Sprocket cover $20 / THROWN OUT
Both radiator infill panels and lower "V" $20 / THROWN OUT
Left carbon fiber cockpit infill panel $40 / THROWN OUT
Steering damper filled with 75w-140 (much more stiff but still a leaky POS) $20 / THROWN OUT
Rear brake rotor $20 / THROWN OUT
Right foot heel guard $10 / THROWN OUT
Radiator fan shroud $15 / THROWN OUT
OE rear suspension linkage $15 / THROWN OUT
OE valve springs $30 / THROWN OUT
Rear brake light sensor $10 / THROWN OUT
Armor Bodies Superbike tail seat pad, self adhering, never used $30 / THROWN OUT
Armor Bodies front fender, new still wrapped in its original foam packing wrap (should fit all years, comes with spacers and reflectors if you want them) $40 / THROWN OUT
You can PM me but its easier to text
Brandon
612-715-1882
"The better you look, the more you see."
Last edited by Victor Ward; 11-11-19 at 12:29.