Daytona not turning over - full battery - Triumph675.Net Forums
 
Thread Tools Display Modes
post #1 of 4 Old 02-06-19, 17:10 Thread Starter
Whitey26
Junior Member
 
Join Date: Feb 2019
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Daytona not turning over - full battery

I’m sure there’s an easy explanation for this so hoping to get some pointers on what’s going on here. Battery is fully charged, fuel is full etc. when I click the ignition the bike literally cuts out and resets. It seems to take longer than normal for computer to go through motions etc and then once it’s finished the whirring sounds I press ignition switch and hear a click, and then all lights and dash power goes off and then comes back on and computer goes through start up process again. Any ideas?
Whitey26 is offline  
Sponsored Links
Advertisement
 
post #2 of 4 Old 02-06-19, 21:19
Plasmablaster
Senior Member
 
Plasmablaster's Avatar
 
Join Date: May 2016
Location: Thessaloniki
Posts: 866
Thanks: 120
Thanked 105 Times in 90 Posts
Garage
Check your battery terminals. I've had this happen to me a couple of times in the past, it was loose battery terminals in both cases. Actually I use zip-ties now to secure them, as I've grown tired of having them get loose due to butter-soft battery screws.


If it's not that, then you probably have a short somewhere, or a bad relay.
Plasmablaster is online now  
post #3 of 4 Old 02-07-19, 01:22
MacBandit
Super Moderator
 
MacBandit's Avatar
 
Join Date: Sep 2008
Location: Seattle
Posts: 11,849
Thanks: 21
Thanked 391 Times in 333 Posts
Garage
How do you know the battery is good? Have you tested the battery with a load on it?
MacBandit is offline  
 
post #4 of 4 Old 10-18-19, 01:59
J Atiwat Thongprapan
Junior Member
 
Join Date: Oct 2019
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
I've experienced the same issue, you need to take the battery to an automotive store to get it tested. Its may have gone bad despite showing proper voltage. Once you replace the battery, test the voltage at the battery terminals with the bike running and rev the bike to about 6k rpm. The voltage should not exceed 14.5V, if it does, your Regulator Rectifier is not working correctly and that is what is toasting your battery by overcharging it.
J Atiwat Thongprapan is offline  
Sponsored Links
Advertisement
 
Reply

Bookmarks

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Triumph675.Net Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode


Forum Jump

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome