Triumph675.Net Forums - Search Results
Advanced Search
Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: MadMel
Forum: General 675 discussion   10-30-19, 22:43
Replies: 65
Views: 8,089
Posted By MadMel
In Australia there's no race class to run an 800...

In Australia there's no race class to run an 800 in, unless you want to be going up against the litrebikes. For me, that's a showstopper for either a Daytona or MV.
Forum: 675 Photos   10-28-19, 20:34
Replies: 729
Views: 156,020
Posted By MadMel
Sorry man, I never noticed the notification that...

Sorry man, I never noticed the notification that you had commented on this. It's a Kendon Sport Bike lift. https://www.kendonusa.com/products/folding-sport-bike-lift-folding-motorcycle-lifts
...
Forum: Repair/Troubleshooting   10-04-19, 16:25
Replies: 9
Views: 694
Posted By MadMel
After some searching, it looks like the cps has a...

After some searching, it looks like the cps has a close relationship with the stator. If the cps goes bad, does that mean the stator is bad? I checked my charging system and it was fine. I don’t much...
Forum: Repair/Troubleshooting   10-02-19, 17:30
Replies: 9
Views: 694
Posted By MadMel
Bike that cranks but won't start is often the...

Bike that cranks but won't start is often the crank position sensor (aka CPS). Checking its impedance only takes a minute and is a good start, the plug is under the tank, should be somewhere in the...
Forum: General 675 discussion   09-18-19, 16:58
Replies: 37
Views: 3,558
Posted By MadMel
Over the years, I've had one that was no good at...

Over the years, I've had one that was no good at low RPM, and two or three that were cutting out at high RPM. I also am curious where E30KK sourced his.
Forum: General 675 discussion   09-10-19, 00:03
Replies: 4
Views: 490
Posted By MadMel
Race tail with stock carbon fiber shield. No...

Race tail with stock carbon fiber shield. No extra mounting bolts required for the tail, just dowel + foam rubber + cloth tape.
Forum: Repair/Troubleshooting   08-31-19, 18:35
Replies: 6
Views: 915
Posted By MadMel
Not familiar with the Bazazz unit, but can you...

Not familiar with the Bazazz unit, but can you run the bike with it disconnected? Because I'd suggest that as a potential culprit.
Forum: All Things Tuning   08-31-19, 18:32
Replies: 15
Views: 3,648
Posted By MadMel
Yes, a good tuner can visualise and adjust the...

Yes, a good tuner can visualise and adjust the map directly using TuneECU without a Power Commander or Bazazz. Mine does it while the bike is on the dyno... Do a run, adjust, do another run, etc.
Forum: Routine Maintenance Questions   08-09-19, 23:38
Replies: 2
Views: 390
Posted By MadMel
Topover sensor is in the nose, behind the...

Topover sensor is in the nose, behind the tachometer.
Forum: General 675 discussion   08-09-19, 16:38
Replies: 11
Views: 1,105
Posted By MadMel
If I may be so bold as to add CPS to the list....

If I may be so bold as to add CPS to the list. Admittedly, it's bought as part of the stator assembly.
Forum: Repair/Troubleshooting   08-06-19, 21:51
Replies: 4
Views: 354
Posted By MadMel
Has the bike been tracked or raced? Stock rotors...

Has the bike been tracked or raced? Stock rotors are shyte, they don't hold up to the heat from track use. I replaced mine a couple of times before I finally grew a brain and bought Brembo T-Drives....
Forum: Maintenance and repair   08-05-19, 16:42
Replies: 2
Views: 304
Posted By MadMel
It's obviously not related to the starting issue,...

It's obviously not related to the starting issue, but "Previously this season, I've had issues with the bike cutting out momentarily when under throttle" is what I've had with two different failing...
Forum: Repair/Troubleshooting   08-04-19, 17:10
Replies: 1,014
Views: 287,900
Posted By MadMel
Exactly. It doesn't matter as it's AC...

Exactly. It doesn't matter as it's AC electricity.[/QUOTE]

Lol, yeah that's a good point. Alternating current. Thanks Plasmablaster.
Forum: Repair/Troubleshooting   08-03-19, 23:00
Replies: 1,014
Views: 287,900
Posted By MadMel
Stator wire order: Based on the voltage outputs...

Stator wire order: Based on the voltage outputs described in the original post, and a response to a post by Hokie early in the thread, it sounds like the order of the stator wires being connected to...
Forum: Repair/Troubleshooting   08-01-19, 19:07
Replies: 8
Views: 578
Posted By MadMel
First thing I'd check is the battery voltage. If...

First thing I'd check is the battery voltage. If it's low, obviously it isn't getting charged, so something upstream of the battery, like the stator / regulator rectifier / a connection. If the...
Forum: General 675 discussion   07-08-19, 08:41
Replies: 1
Views: 344
Posted By MadMel
A fairly quick check is to go on BikeBandit and...

A fairly quick check is to go on BikeBandit and look at the fiches. If it's the same Triumph part number, it's the same part.
Forum: Performance Mods   07-05-19, 11:34
Replies: 115
Views: 20,875
Posted By MadMel
Pozi is a decent alternative to not having a JIS...

Pozi is a decent alternative to not having a JIS screwdriver. Way better than Phillips.
Forum: Want To Buy   06-29-19, 06:25
Replies: 2
Views: 391
Posted By MadMel
If you don't have any luck, TJ from...

If you don't have any luck, TJ from RidersDiscount on this forum can hook you up with a MotoHolders stay, in either street or track configuration.
Forum: General 675 discussion   06-28-19, 21:23
Replies: 9,269
Views: 809,501
Posted By MadMel
what he said... and (pic) although I may be...

what he said... and (pic) although I may be missing something under the tail that would cover the hole... not sure what all is missing from this bike... new project for me![/QUOTE]
I was lazier lol....
Forum: General 675 discussion   06-28-19, 12:26
Replies: 9,269
Views: 809,501
Posted By MadMel
How does one pop the front seat without a...

How does one pop the front seat without a key?![/QUOTE]
A long cable tie to the latch mechanism, so when you pull the cable tie, it opens the seat latch. Hang the tag end of the tie down between the...
Forum: Routine Maintenance Questions   06-27-19, 21:18
Replies: 11
Views: 1,357
Posted By MadMel
Likely problems with the o-ring. If a poor...

Likely problems with the o-ring. If a poor quality filter ruptures and dumps oil, the risk is to other racers.
Forum: General 675 discussion   06-24-19, 10:24
Replies: 3
Views: 333
Posted By MadMel
I'd check the battery and ground wiring under the...

I'd check the battery and ground wiring under the seat, make sure there isn't a loose connection.
Forum: General 675 discussion   06-23-19, 22:33
Replies: 6
Views: 637
Posted By MadMel
What *******s at the dealer. Honda/Acura crush...

What *******s at the dealer. Honda/Acura crush washers fit, I think I bought 50 or 100 on eBay for a few dollars. Make sure you tell them that those few pennies cost them your future business.
...
Forum: Routine Maintenance Questions   06-23-19, 00:17
Replies: 11
Views: 1,357
Posted By MadMel
I'm in Oz, so maybe different options from you....

I'm in Oz, so maybe different options from you. I've ordered from eBay, dealers, and Jack Lilley in the UK.

Interestingly, the last half dozen I received have a different part number, and seem to...
Forum: Routine Maintenance Questions   06-22-19, 21:12
Replies: 11
Views: 1,357
Posted By MadMel
Stock Triumph filters. Been using them with a...

Stock Triumph filters. Been using them with a full Akra for 7 years.
Showing results 1 to 25 of 500

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome