Triumph675.Net Forums - Reply to Topic
Maintenance and repair Problems, fixes, general maintenance talk

Thread: 07 Daytona Fuel pump relay not triggering. Reply to Thread
Title:
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Triumph675.Net Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
10-16-19 00:49
Triple_Sins I know this may sound stupid, but check your Tip over sensor. A lot of times when we take our bikes apart, we forget that little sensor up by the intake. I had the same issue this last winter when I did a massive overhaul of the entire bike. I was getting power everywhere I needed it, relays were good, grounds were good, but the fuel pump wouldn’t prime and the bike wouldn’t start.

Again, that’s just something that sounds familiar to my incident that drove me nuts for a few days. After the fact I couldn’t believe I forgot all about that sensor.

Good luck
08-31-19 06:11
Ianr ...the small plugs on the relay subloom connect to the sai plugs up under the airbox.
08-28-19 22:23
Ianr
07 Daytona Fuel pump relay not triggering.

Hey there,


I have just completed the valve shim service and the bike now is not getting 12v to the fuel pump.


Its a 07 daytona with the fuel pump relay wiring sub loom.


The bike starts and runs when I bridge the 12v constant with the white purple (which goes direct to the pump) at the relay plug.


I have continuity from the pin 29 at the ecu and the black purple at the white plug from the ecu.


So effectively I am missing the signal from the ecu to trigger the relay to provide power with the switch of the key on.



Any clues please!


Also on the relay sub loom do the little black and little white plugs clip into each other or something else that I have forgotten about? (I read something mentioning the SAI plugs but this doesnt seem right or possible).


Thank you very much as I am at a dead end.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome