Triumph 675 Forums banner

WTF! This upper fairing comes apart how???

2K views 3 replies 2 participants last post by  TwoWheeledWonder 
#1 ·
Swapping out fairings completely... I got it all unhooked minus where the intake snorkel connects to the frame...

I separated it from the frame that and that is where the problem arises...

1. I want to swap out the upper fairing, but.... The harness is all in and out of this upper piece. Where and how does it disconnect?

2. Do I have to remove the snorkel completely, then upper stay, cluster, and so on before I can access just the upper fairing?

How do I isolate upper fairing from all the other components and main harness.
 
#4 ·
Take off the side fairing bolts should be four. Two on side and two on infills. Then on the under side there are two plastic screws. Next take off the mirrors and wind screen screws.
After that there are two bolts down inside by the dash. They will be hex like the side fairings.
That will get the noise fairing off. Also there should be a plug going to the headlights on the left side. Then boom nose separated from the bike.

If you are just swapping fairings you shouldnt be taking the snorkel off.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top