Triumph 675 Forums banner

'14 675R Block Off Plates Install

2K views 7 replies 4 participants last post by  Redline87 
#1 ·
Finally decided to give it a go with installing the Driven Block off plates on my 2014 675R. I have everything installed and tight, bike fires right up and idles fine dont see any issues howerver after the install the CEL is on.

I have the stock wiring harness on the bike, does this plug the PAIR system used to plug into need some type of resistor to clear the CEL? Is there any way to get a code from the dash to confirm my suspisions?

Thanks guys. Did a video on the install that ill upload once I sort this out.

Any help is greatly appreciated.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top