What did you do to your Street Triple today?

[spike_africa]

Originally Posted by JDub

How many miles you at?

Just under 18,000 miles.

Originally Posted by jk0311

Damn dude, where is it? Your garage or at the stealership?

No no, I do my own work. Not very hard on these bikes. Cam's are out everything is out. Just waiting on parts to come in. local dealer didn't have anything in stock.

[Johnnystriple]

Just plug her up to the battery tender.

[vintagespeed]

Originally Posted by ANZAC

50 is a little cold at least you had sun and were dry....

the morning commute has been a little chilly lately, in the low 40s. i'm not sure how much colder it is at 120mph though, but it's definitely colder.

[Nastybutler]

Originally Posted by vintagespeed

the morning commute has been a little chilly lately, in the low 40s. i'm not sure how much colder it is at 120mph though, but it's definitely colder.

While this chart doesn't go to 120mph, it does give you the formula to find out for yourself.

Sent by carrier pigeon.

[vrptstyly]

Pic no worky, I want to check it out. Charts make me fuzzy inside. haha

[Zen]

Installed engine covers, seat cowl, and cf front fender.


Sent from my iPhone using Motorcycle.com Free App

[Zen]

Oh...and put on some zen circles...

I noticed the forum slows down a bit during the cold and wet days.

Sent from my iPhone using Motorcycle.com Free App

[Scottie]

1. installed a prototype bracket which moves the instruments out a couple cm.
2. installed a flasher relay for the turn signals
3. installed a radiator guard
4. installed some nice renthal clipons (from TJ)

Since I got a little money for xmas, I think I will go and do a little shopping and see if I can't come up with something else I need for my bike.

My lovely gf also got me a new rear tire for xmas, but haven't installed it yet.

Scott

[f4nm4n]

What does the flasher relay for your signals do? or was it just to replace a defective one? Oh and im around the corner from hamilton, we should meet up for a boot come spring

[Scottie]

Originally Posted by f4nm4n

What does the flasher relay for your signals do? or was it just to replace a defective one? Oh and im around the corner from hamilton, we should meet up for a boot come spring

If you install any sort of led turn signals, (and don't install resistors or a flasher relay) then your turn signals will flash too quickly. It comes down to the resistance in the leds is too low, so the stock relay thinks there is a dead bulb. The new one just slows the turn signal down so it flashes at a normal speed.

Ya I know where Binbrook is. I'm actually in Burlington now (I need to change that apparently), but still close enough. Sounds good to me... but we may have to wait a little bit, I think it's a little too cold and snowy for me right now!

Scott