|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||
|
|||||||||
|
|||||||||
|
|
| Not A Member Yet? Register today and become part of the community. |
|
| |||||||
| Parts Sell, trade or give away your parts here. FS, WTT, FF all welcome. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
12-06-12, 15:16
|
#1 |
|
Member
Join Date: Aug 2011
Location: Fort Benning, GA
Posts: 540
|
Feeler: Stripped wiring harness & ECU
I wanted to see if anyone would be interested... I have stripped my old wiring harness for the track (2nd Gen 09-12). I eliminated a ton of the stuff like lights, snorkel valve, kickstand sensor, shift sensor and stuff. Took out a ton of wire, more can still be removed like the idle adjuster, o2 sensor. I could also put the clutch sensor back in since I just bought a new sensor the other day before I changed my plans again!
I just bought a used race ecu, and quickshift so I will have to get the race harness. I no longer need the stock (stripped) harness or ecu. Instead of it just laying around I wanted to know if anyone needed this? I know some people are not willing to strip into a perfectly good harness, the work is already done here. This is only a feeler, because I have a lot of the tape pulled off the harness, I was getting ready to strip the ignition, o2 sensor, idle controller and some other stuff before I ran across that smoking deal, I will have to re-tape up the harness, but will not bother if no one needs it. Last edited by sittingturbo; 12-06-12 at 15:29. |
|
Status: Offline
|
|
| Sponsored Links | |||
Advertisement | |||
|
12-08-12, 02:38
|
#2 |
|
BOTM Winner
 
Join Date: Nov 2007
Location: Norcal
Posts: 833
 |
How much for the ECU?
|
|
Status: Offline
|
|
|
12-08-12, 09:11
|
#3 |
|
Member
Join Date: Aug 2011
Location: Fort Benning, GA
Posts: 540
|
Lets say 150 shipped which is much cheaper then anything on eBay.
|
|
Status: Offline
|
|
| Sponsored Links | |
Advertisement | |
|
| Bookmarks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|||||
Linear Mode
