tuneecu stalling?

[jnip87]

ok i have the bike hooked up and running right now, and i hav ea p1105 map sensor pipe fault code? any ideas? also i did adjust the throtle cable to take out some slop before i tuned it, could that be causing this?

[jnip87]

ok it has been running for about a half hour now and still no little arrrow change or green tps light! wtf!!!! it says insufficient engine temp..

[jnip87]

anyone? could really use some helpful info here...

[MacBandit]

It's your MAP sensor. It's not connected correctly.

[675r4me]

Originally Posted by MacBandit

It's your MAP sensor. It's not connected correctly.

Once again, MacBandit nailed it. I have always wanted to compliment you on your astute knowledge of these bikes. Sincerely,

Mark

[jnip87]

does it connect anywhere other than under the tank on top of the airbox? because that was pluged in and snaped tight...

[Travisty]

Check the hose that is supposed to be plugged into the bottom of the map sensor. I see this all the time, and have done it myself.

[jnip87]

this is going to sound completely retarted, but now that im looking through my sevice manual, im confused if im looking at the map sensor or not, i think im looking at the wrong connector, and where is this hose if you dint mind. i feel so stupid right now.

[jnip87]

Originally Posted by MacBandit

It's your MAP sensor. It's not connected correctly.

Originally Posted by Travisty

Check the hose that is supposed to be plugged into the bottom of the map sensor. I see this all the time, and have done it myself.

HA! i jsut found the map sensor and that HOSE was not connected to it, i was looking at the damn air temp sensor. you guys are swesome thanks so much, now lets try this again....