Well sorted 2006 675 Race Bike- Denver, CO

Desmo · 11-05-12, 11:36

Putting this out to see if there is any interest, not going to give it away as it can sit in the garage until spring.

2006 Triumph 675- Salvage title- never down on the track, lowsided on street before I bought it and built a race bike from scratch. Currently has a vinyl wrap, easily removed if you want to paint it. Bodywork in very good condition no cracks or issues. Motor has about 3,500 miles on it and I recently replaced injectors and plugs and it runs very well. Motul Full Synthetic changed regularly. Could use a new dyno tune as current tune was done with a bad air pressure sensor so it would make more hp with a new one but runs fine as is. It is mapped for pump gas so you could get more if you mapped it for race gas. Bike is very light, around 365 pounds using the bathroom scale method, svelte and changes direction very quickly.

Goodies-

-Motor built by Steve Upchurch (CMRA) with numerous Triumph kit parts- Race Generator, Valves, Springs, Cams, Chain tensioner, adjustable cam sprockets, SAI block off plates
-Triumph Race ECU
-Triumph Race wiring harness (keyless ignition)
-Slipper Clutch, clutch plates replaced three race weekends ago
-GB Racing engine guard
-BMC air filter
-Leo Vince full exhaust
-Power Commander
-Woodcraft Rear Sets
-Woodcraft clip-ons
-Brembo RCS19 Master Cylinder
-CRG clutch lever
-EBC pads
-Yoyodyne fairing stay
-Hyperco adjustable steering damper
-Penske 2 way shock
-Cogent Dynamics fork cartridges
-Lithium battery
-Fuel tank foam to prevent sloshing

Pic links below, let's start at $5,500, willing to negotiate a little but not looking to give it away as it is worth way more parted out but would prefer not to deal with that. Asking price includes Pit Bull stands and a few spare bits I have acquired as well.

http://www.flickr.com/photos/39272157@N07/8158142826/
http://www.flickr.com/photos/39272157@N07/8158143074/
http://www.flickr.com/photos/39272157@N07/8158171062/

Disrupt · 11-05-12, 11:53

Very cool bike, good luck with the sale!

owweee · 11-05-12, 15:42

Check your PM...=)

Geof3 · 11-09-12, 01:16

Dang, sweet bike. Still can't decide if I want to start racing on a 675 or do it "right" on a 250... Love that vinyl wrap. Very cool!

whirlybird · 11-09-12, 17:52

Do you race in the MRA? I haven't seen that bike around before

NavalAv8r · 11-14-12, 17:10

I want this in a bad kind of way. Need to get rid of my bike first though :(

jethead · 11-14-12, 20:34

I have that helmet! Love it!

Desmo · 01-24-13, 15:36

New price- $4,999.99

Desmo · 02-06-13, 22:11

More pics here: http://weraclassifieds.com/ads/06-tr...675-race-bike/

Fastt Racing · 02-17-13, 19:13

The owner of this machine is a class act to deal with. This bike is very fast, and I would highly recommend this machine to anyone looking to go racing.

11-05-12, 11:36	#1
Desmo Member Join Date: May 2009 Location: CO Posts: 155	Well sorted 2006 675 Race Bike- Denver, CO Putting this out to see if there is any interest, not going to give it away as it can sit in the garage until spring. 2006 Triumph 675- Salvage title- never down on the track, lowsided on street before I bought it and built a race bike from scratch. Currently has a vinyl wrap, easily removed if you want to paint it. Bodywork in very good condition no cracks or issues. Motor has about 3,500 miles on it and I recently replaced injectors and plugs and it runs very well. Motul Full Synthetic changed regularly. Could use a new dyno tune as current tune was done with a bad air pressure sensor so it would make more hp with a new one but runs fine as is. It is mapped for pump gas so you could get more if you mapped it for race gas. Bike is very light, around 365 pounds using the bathroom scale method, svelte and changes direction very quickly. Goodies- -Motor built by Steve Upchurch (CMRA) with numerous Triumph kit parts- Race Generator, Valves, Springs, Cams, Chain tensioner, adjustable cam sprockets, SAI block off plates -Triumph Race ECU -Triumph Race wiring harness (keyless ignition) -Slipper Clutch, clutch plates replaced three race weekends ago -GB Racing engine guard -BMC air filter -Leo Vince full exhaust -Power Commander -Woodcraft Rear Sets -Woodcraft clip-ons -Brembo RCS19 Master Cylinder -CRG clutch lever -EBC pads -Yoyodyne fairing stay -Hyperco adjustable steering damper -Penske 2 way shock -Cogent Dynamics fork cartridges -Lithium battery -Fuel tank foam to prevent sloshing Pic links below, let's start at $5,500, willing to negotiate a little but not looking to give it away as it is worth way more parted out but would prefer not to deal with that. Asking price includes Pit Bull stands and a few spare bits I have acquired as well. http://www.flickr.com/photos/39272157@N07/8158142826/ http://www.flickr.com/photos/39272157@N07/8158143074/ http://www.flickr.com/photos/39272157@N07/8158171062/ __________________ 2006 675 Racebike Thanks to: Toyota, Sol Performance, Pirelli, Motowheels.com, 303cycle.com, Cogent Dynamics MRA#91
Status: Offline

11-05-12, 11:53	#2
Disrupt Senior Member Join Date: May 2011 Location: Queens, NY Posts: 1,450	Very cool bike, good luck with the sale! __________________ 1993 Mitsubishi 3000GT VR-4 2007 D675
Status: Offline

11-05-12, 15:42	#3
owweee Junior Member Join Date: Mar 2011 Location: Atlanta Georgia Posts: 115	Check your PM...=)
Status: Offline

11-09-12, 01:16	#4
Geof3 Member Join Date: Jul 2012 Location: Colorado Springs Posts: 400	Dang, sweet bike. Still can't decide if I want to start racing on a 675 or do it "right" on a 250... Love that vinyl wrap. Very cool!
Status: Offline

11-09-12, 17:52	#5
whirlybird Senior Member Join Date: May 2007 Location: Colorado Posts: 2,625	Do you race in the MRA? I haven't seen that bike around before
Status: Offline

11-14-12, 17:10	#6
NavalAv8r Member Join Date: Jun 2009 Location: Angleton, TX Posts: 155	I want this in a bad kind of way. Need to get rid of my bike first though :(
Status: Offline

11-14-12, 20:34	#7
jethead Member Join Date: Jun 2011 Location: Hampton, VA Posts: 174	I have that helmet! Love it! __________________ The sheep remain inside the pen, Though many times they've seen the way to leave.
Status: Offline

01-24-13, 15:36	#8
Desmo Member Join Date: May 2009 Location: CO Posts: 155	New price- $4,999.99 __________________ 2006 675 Racebike Thanks to: Toyota, Sol Performance, Pirelli, Motowheels.com, 303cycle.com, Cogent Dynamics MRA#91
Status: Offline

02-06-13, 22:11	#9
Desmo Member Join Date: May 2009 Location: CO Posts: 155	More pics here: http://weraclassifieds.com/ads/06-tr...675-race-bike/ __________________ 2006 675 Racebike Thanks to: Toyota, Sol Performance, Pirelli, Motowheels.com, 303cycle.com, Cogent Dynamics MRA#91
Status: Offline

02-17-13, 19:13	#10
Fastt Racing Junior Member Join Date: Oct 2010 Location: Colorado Posts: 98	The owner of this machine is a class act to deal with. This bike is very fast, and I would highly recommend this machine to anyone looking to go racing.
Status: Offline

Remove Advertisements Sponsored Links
Triumph675.net Advertisement

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode